CAUTION: Do not pull directly on high tension wire. It may separate from connector in boot. Grasp boot by hand and remove with a twisting motion.
Disconnect high tension wire at ignition coil (12029).
Section 03-07A: Ignition, Distributor | 1996 F-Series and Bronco with Gasoline Engines Workshop Manual |
Removal
Disconnect wiring harness at ignition coil.
CAUTION: Do not pull directly on high tension wire. It may separate from connector in boot. Grasp boot by hand and remove with a twisting motion.
Disconnect high tension wire at ignition coil (12029).
Remove ignition coil to bracket attaching screws and removeignition coil.
Installation
Follow removal procedures in reverse order.
Tighten ignition coil to bracket attaching screws to 2.8-4.0 Nm (25-35 lb-in).