Section 03-14: Engine Controls, Electronic
1996 F-150, F-250, F-350, F-Super Duty Series and Bronco Vehicles Workshop Manual
REMOVAL AND INSTALLATION

Injector Driver Module (IDM)

Diesel Engine

Removal

  1.  WARNING: RED-STRIPED WIRES CARRY 115V DC. SEVERE ELECTRICAL SHOCK MAY BE RECEIVED. DO NOT PIERCE.

     CAUTION: Do not pierce engine electrical wires or damage to the harness may occur.

    Disconnect battery negative cable.

  1. Remove module bolts.

  1. Loosen wiring connector retainer bolt.

  1. Remove injector driver module.

Installation

  1. To install, reverse removal procedures.

  1. Tighten IDM retainer bolt to 3-4 Nm (27-35 lb-in).