Section 04-01B: Suspension, Front, 4-Wheel Drive
1996 F-150, F-250, F-350 4x4 and Bronco Workshop Manual
REMOVAL AND INSTALLATION

Shock Absorber, F-250 and F-350

 CAUTION: The low pressure gas front shock absorbers (18124) are charged with nitrogen gas to 931 kPa (135 psi) for 1-inch and 1-3/16-inch bore, and 1034 kPa (150 psi) for 1-3/8-inch bore. Do not attempt to open, puncture or apply heat to the shock absorbers.

Removal

  1. Remove front shock absorber-to-upper shock bracket nut and bolt.

  1. Disconnect the lower end of the front shock absorber bolt and nut from the U-bolt plate.

  1. Compress the front shock absorber and remove.

Installation

  1. Insert front shock absorber into the front shock absorber mounting bracket (18183). Insert bolt and tighten nut to 60-81 Nm (45-60 lb-ft).

  1. Attach the lower end of the front shock absorber to the U-bolt plate by installing the nut and bolt. Tighten to 60-81 Nm (45-60 lb-ft).