While the assistant holds the intermediate cable, insert a 4mm (0.156 in.) pin into the hole provided in the parking brake control (2780).
Section 06-05: Brake System, Parking | 1996 Bronco, F-150, F-250, F-350, F-Super Duty Chassis Cab and Motorhome Chassis Vehicles Workshop Manual |
Removal
Remove the LH cowl side panel (02038).
To gain the needed slack, have an assistant pull the intermediate cable toward the rear of the vehicle.
While the assistant holds the intermediate cable, insert a 4mm (0.156 in.) pin into the hole provided in the parking brake control (2780).
Disconnect the intermediate cable from the cable connector.
| Item | Part Number | Description |
|---|---|---|
| 1 | 2780 | Parking Brake Control |
| 2 | 2853 | Front Parking Brake Cable and Conduit |
| 3 | 2A793 | Intermediate Cable |
Disconnect the intermediate cable from the parking brake cable equalizer.
Remove the intermediate cable from the vehicle.
Installation
Follow removal procedures in reverse order.
Parking Brake Cables
| Item | Part Number | Description |
|---|---|---|
| 1 | 3B139 | Steering Column Support Bracket |
| 2 | 2780 | Parking Brake Control |
| 3 | 2853 | Front Parking Brake Cable and Conduit |
| 4 | 2A793 | Cable, Intermediate |
| 5 | 2A602 | Parking Brake Cable Equalizer |
| 6 | N647097-S | Rivet |
| 7 | 2530 | Parking Brake Cable Bracket |
| 8 | 2A635 | Parking Brake Rear Cable and Conduit, Left |
| 9 | 57632-S2 | Screw and Washer, Cable Clip-to-Differential |
| 10 | N804729-S100 | Clip |
| 11 | 2A635 | Parking Brake Rear Cable and Conduit, Right |
| 12 | N620481-S2 | Nut, Parking Brake Control-to-Steering Column Support |
| 13 | 40949-S2 | Screw, Cable Clip-to-Frame |
| 14 | N800962-S32 | Clip, 10 x 10 |
| A | — | Tighten to 17-23 Nm (13-17 Lb-Ft) |
| B | — | Tighten to 17-23 Nm (13-17 Lb-Ft) |
| C | — | Tighten to 24-30 Nm (18-22 Lb-Ft) |