Section 07-03A: Transmission, Manual, M5OD
1996 F-Series and Bronco (under 8500 lbs. GVW) with 4.9L and 5.0L Engines Workshop Manual
INSTALLATION

Shift Lever and Boot

  1. Install the retaining bolt in the shift lever hole such that the flat aligns with the mating flat on the transmission stub shaft. Push bolt fully into position. Install nut and tighten to 16-24 Nm (12-18 lb-ft).

  1. Slide the gearshift lever boot (7277) into position on the gearshift lever and housing, and install the retaining screws.

  1. Install the isolator pad assembly. Install the floor pan cover and floor carpet if previously removed.