Bearings

1. Rotate the bearings in a cleaning solvent until all lubricant is removed. Hold the bearing assembly to prevent it from rotating while drying it with compressed air.

2. Lubricate the bearings with approved transmission lubricant. Wrap them in a clean, lint-free cloth or paper, until ready for use.

Raceways

1. NOTE: Bearings that have been removed using special service tools may have been damaged simply due to the tool design. Be sure the following checks are made to determine if the bearing can be put back into service.

   Inner Ring Raceway — While holding outer ring stationary, rotate inner ring at least three revolutions. Examine raceway of inner ring for pits or spalling. If pits or spalling are unacceptable, replace the bearing assembly. Light particle indentation is acceptable.

2. Outer Ring Raceway — While holding inner ring stationary, rotate outer ring at least three revolutions. Examine raceway of the outer ring from the same side as the raceway of the inner ring. If raceway is spalled or pitted, replace the bearing assembly. Light particle indentation is acceptable.

External Surfaces

The bearing must be replaced if damage is found in any of the following areas:

1. Radial cracks on front and rear faces of outer or inner rings.

2. Cracks on outside diameter or outer ring (particularly around snap ring groove).

3. Deformation or cracks in ball cage (particularly around rivets).

Spin Test

1. Lubricate bearing raceways with a slight amount of clean oil. Turn the bearing back and forth slowly until raceways and balls are coated with oil.

2. Hold bearing by inner ring in a vertical position. Vertical movement between the inner and outer rings is acceptable. Spin outer ring several times by hand (do not use compressed air). If roughness or vibration is noticeable or the outer ring stops abruptly, the bearing should be cleaned again and lubricated. Roughness in a bearing is usually caused by foreign particles in the bearing, which comes from inside the transmission case (7005). If bearing is still rough after cleaning and relubricating three times, it must be replaced.

3. Hold bearing by the inner ring in a horizontal position. Spin outer ring several times by hand (do not use compressed air). If bearing is still rough after cleaning and relubricating three times (if not done in Step 2), it must be replaced. If bearing passes the visual inspection and spin tests, it can be reinstalled in transmission (7003).