Heat the detent mounting area in the shift lever housing to approximately 120°C (248°F). Press the detent into its mounting hole until it rests against its stop in the base of the hole.
Section 07-03B: Transmission, Manual, Model S5-47 ZF | 1996 F-Series Vehicles Over 8500 lbs. GVW Workshop Manual |
NOTE: Disassembly of parts inside the shift lever housing should be confined to replacement of the detent when necessary.
If required, install a new detent in the shift lever housing. Using Rotunda Heat Gun 107-R0300 or equivalent.
Heat the detent mounting area in the shift lever housing to approximately 120°C (248°F). Press the detent into its mounting hole until it rests against its stop in the base of the hole.