Section 14-02A: Generator, Integral Rear Mounted Regulator, Internal Fan Type, 95 Ampere and 130 Ampere
1996 F-Series, Bronco Workshop Manual
REMOVAL AND INSTALLATION

Generator, 5.0L, 5.8L, 7.3L Engines

Removal

  1. Disconnect battery ground cable (14301).

  1. Disconnect electrical connectors from generator (GEN) (10346).

  1. Remove drive belt (8620).

  1. Remove generator retaining bolts (3).

  1. Remove generator.



    Generator





    ItemPart NumberDescription
    1—Fuel Filter Assembly
    (Part of 9K601)
    219703A/C Compressor
    38146Fan Shroud
    410A313Generator Bracket
    510346Generator
    6389706-S2Generator Retaining Bolts (3)
    7—Heater Hose Clip
    8—Heater Hose
    A—Tighten to 21-29 Nm
    (16-21 Lb-Ft)

Installation

  1. Install generator.

  1. Install generator retaining bolts (3). Tighten bolts to 21-29 Nm (16-21 lb-ft).

  1. Install drive belt.

  1. Connect electrical connectors to generator.

  1. NOTE: When the battery (10655) has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control module (PCM) (12A650) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.

    Connect battery ground cable.